DMP Electronics XTLC - Messaging Options and Limits

Digital Monitoring Products XTL/XTLC Programming Guide
10
MESSAGING SETUP
4.8
DESTINATION 3
-
Destination 3
Enter the third destination email address or cell phone number.
4.9 Destination 3 User Number
If Destination 3 is a cellular number, enter the user’s User Number for
arming/disarming authorization.
4.10
O/C EMAIL NO YES
O/C Email
Select YES to allow the panel to send Opening and Closing reports via email. Default is
NO. This prompt appears only if any destination is an email address.
4.11
O/C SMS NO YES
O/C SMS
Select YES to allow the panel to send Opening and Closing messages to a cell phone via
SMS protocol. Default is NO. This prompt appears only if any destination is a cell phone
number.
4.12
MONTHLY LIMIT: 0
Monthly Limit
This option displays if any programmed destination is a cell phone number or an
email address. This number limits the monthly incoming and outgoing SMS messages
allowed to be sent or received by the panel.
A panel event that causes messages to be sent to destination cell phone numbers
or destination email addresses is counted towards the panel’s monthly limit. For
example, if an alarm message is sent to a cell phone number and an email address,
a total of 2 messages are counted towards the monthly limit for the panel. SMS
messages sent from a cell phone to the panel, including status requests and
MyAccess™ text messaging commands, also count toward the monthly limit. The
limit is reset at midnight on the 14th of every month. Range is from 0 to 999.
When 0 is entered, there is no limit on the number of messages able to be sent or
received by the panel. Default is 0.
Note: The SecureCom Wireless text plan selected for the panel should match or
exceed the programmed Monthly Limit.
DESTINATION 3
USER NUMBER: 0