To Next Page

To Previous Page

Digital Monitoring Products XTL/XTLC Programming Guide

Stop

14.1

STOP

Stop

At the STOP prompt, pressing any Select key allows you to exit the programmer

function of the XTL/XTLC panel. When selected, the panel performs an internal

reset and exits the programmer. The Stop function causes the following conditions

to occur:

• All 1100 Series DMP Wireless transmitters are reset to NORMAL

• The panel’s Status List is CLEARED

During the Stop function, all keypad displays are momentarily disabled for two

seconds. Afterwards, the programming function is terminated and the keypads

return to the Status List display.

SET LOCKOUT CODE

Set Lockout Code

15.1

SET LOCKOUT CODE

Set Lockout Code

Pressing COMMAND at the Stop prompt displays SET LOCKOUT CODE. This feature

allows you to program a special code that will then be required to gain access to

the panel’s internal Programmer through the keypad.

Changing the Lockout Code

You can change this code at any time to any combination of numbers from 1 to 5

digits long (1 to 65535). Do not use leading zeros for the lockout code.

1. Press any Select key. The display changes to ENTER CODE: -.

2. Enter a 1- to 5-digit code (do not enter a number higher than 65535). Press

COMMAND.

3. Enter the new Lockout Code again. Press COMMAND. The keypad display

changes to CODE CHANGED.

Once you have changed the code, it is important that you write it down and store

it in a safe place. Lost lockout codes require the panel to be sent back into DMP for

repair. You may cancel a Lockout Code by entering 00000 at the Set Lockout Code

command prompt.

Lockout Code restriction

Do not set a Lockout Code higher than 65535.

STOP

DMP Electronics XTLC User Manual

Questions and Answers: