142 Instructions for use Isolette 8000 plus SW 5.n
Reprocessing
12.5.5.4 Reprocessing the heater radiator and fan impeller
WARNING
Risk of death or serious injury
Failure to clean the heater radiator and fan impeller could result in sufficient lint
build-up to reduce airflow. Reduced airflow could affect the temperature control and
cause high oxygen concentrations.
► Clean heater radiator and fan impeller.
CAUTION
Risk of injury or damage to the device
Autoclaving can damage equipment or impact functional integrity.
► Do not steam sterilize parts when disassembling for cleaning.
► Do not immerse the heater assembly in liquid.
CAUTION
Risk of injury or damage to the device
Damage can occur to the motor if liquid penetrates the area.
► When cleaning the incubator shell, prevent liquids from entering the motor shaft
opening.
► When cleaning the surface of the air circulation well, prevent liquids from
entering the motor shaft opening.
1 Remove any lint build-up on the heater radiator and fan impeller.
2 Wipe the heater assembly using a low-level or intermediate-level disinfectant,
Refer to Disinfectants on page 138.
Do not immerse the heater assembly in liquid.
12.5.5.5 Reprocessing the air inlet filter chamber and cover
WARNING
Risk of death or serious injury
A dirty air inlet filter could affect performance or cause carbon dioxide (CO
2) build-
up.
► Ensure that the filter is checked on a routine basis commensurate with local
conditions and replaced as recommended in Maintenance on page 149.
Particularly, if the device is used in an unusually dusty environment, more
frequent replacements may be necessary.
Do not clean the air inlet filter (see Maintenance instructions on page 150).
1 Clean the filter chamber and its cover. Refer to Disinfectants on page 138.
2 Install a new air inlet filter.
To Next Page
Loading...
