36
Monitoring Mode for EN50160 Voltage Compliance
The following screen appears if the selected monitoring mode is Voltage
Compliance (EN50160):
If the default settings for the specified monitoring mode are acceptable,
proceed to the next tab Finalize (if there is nothing else to change). If
Strict Compliance is not checked, you can customize the setting on this
screen.
Finalize Monitoring Setup
Once the instrument has been set up for monitoring or after reading a
setup template from memory, you can finalize and configure the
monitoring process using the parameters below.
Start/Stop Monitoring Conditions
Under the Start monitoring options, select one from the following:
Immediate - to begin monitoring immediately
Delay - use the window provided to enter the number of days, hours,
minutes or seconds of delay to start monitoring from the present time
Specified time and date - use the corresponding windows provided to
specify the time and date when monitoring begins