53
the WAN interface.
Source IP Any - Any data traffic coming from the source IP will be forwarded to a
LAN.
IP Address - Set a range of IP addresses. Any data traffic coming from
the IP addresses within the range will be forwarded to a LAN.
IP Object - Use the drop down list to specify an IP object profile.
IP Group - Use the drop down list to specify an IP group profile.
Private IP Specify a LAN IP address or a range of LAN IP addresses to which the
traffic will be forwarded.
Single - Specify a destination LAN IP address that will receive the
forwarded traffic.
Range - Specify a range of destination LAN IP addresses that will
receive the forwarded traffic.
Port Forwarding
+Add Click to set port numbers for the specified protocol (TCP, UDP, or
TCP/UDP) for a port forwarding profile.
Protocol - The protocol to which this rule applies, TCP, UDP or
TCP/UDP.
Public Port Start - Specify which port can be redirected to the
specified Private IP and Port of the internal host. Enter the required
number as the starting port.
Public Port End - Enter the required number as the ending port.
Private Port Start - The port on each LAN client to which the traffic
will be directed to. Enter the required number as the starting port.
Private Port End - Enter the required number as the ending port.
Options - Click Delete to remove the selected entry.
Cancel Discard current settings and return to the previous page.
Apply Save the current settings and exit the page.
After finishing this web page configuration, please click Apply to save the settings.
To Next Page
Loading...
