Draytek Vigor2926L User Manual

Vigor2926 Series User’s Guide
114
When you finish the configuration, please click OK to save and exit this page.
I
I
I
I
-
-
2
2
-
-
1
1
-
-
3
3
D
D
e
e
t
t
a
a
i
i
l
l
s
s
P
P
a
a
g
g
e
e
f
f
o
o
r
r
I
I
P
P
R
R
o
o
u
u
t
t
e
e
d
d
S
S
u
u
b
b
n
n
e
e
t
t
Available settings are explained as follows:
Item Description
Network Configuration Enable/Disable - Click Enable to enable such configuration;
click Disable to disable such configuration.
For Routing Usage,
IP Address - Type in private IP address for connecting to a
local private network (Default: 192.168.1.1).
Subnet Mask - Type in an address code that determines the
size of the network. (Default: 255.255.255.0/ 24)
RIP Protocol Control,
Disable - deactivate the RIP protocol. It will lead to a
stoppage of the exchange of routing information between
routers. (Default)
Enable – activate the RIP protocol.
DHCP Server
Configuration
DHCP stands for Dynamic Host Configuration Protocol. The
router by factory default acts a DHCP server for your network
so it automatically dispatch related IP settings to any local
user configured as a DHCP client. It is highly recommended
that you leave the router enabled as a DHCP server if you do
not have a DHCP server for your network.
If you want to use another DHCP server in the network other
than the Vigor Router’s, you can let Relay Agent help you to
redirect the DHCP request to the specified location.
Start IP Address - Enter a value of the IP address pool for the
DHCP server to start with when issuing IP addresses. If the
1st IP address of your router is 192.168.1.1, the starting IP
address must be 192.168.1.2 or greater, but smaller than
192.168.1.254.

Draytek Vigor2926L Specifications

General

Brand	Draytek
Model	Vigor2926L
Category	Network Router
Language	English