Draytek Vigor2926L User Manual

Vigor2926 Series User’s Guide
20
7
 Route Policy – Use the drop down list to choose an
existed route policy profile.
 Gateway IP – Specific gateway is used only when you
want to forward the packets to the desired gateway.
Usually, Default Gateway is selected in default.
Priority Packets will be transmitted based on all routes or Route
Policy. Vigor router will determine which rule will be
adopted for transmitting the packet according to the
priority of Static Route and Route Policy.
The greater the value is, the lower the priority is. Default
value for route policy is “200” which means it has higher
priority than the default route.
Failback- When Failover to option is enabled,
Administrator could also enable Failback to clear the
existing session on Failover interface and return to the
original interface immediately once the original interface
resume its service. When Failback is not enabled, the
router will only stop sending packets via the Failover
interface when the existing sessions are cleared, and this
might take a long time because some application will keep
sending packet once a while. Therefore, Failback option is
recommended if Administrator wants the traffic to go via
the primary interface as soon as possible.
3. When you finish the configuration, please click OK to save and exit this page.
I
I
I
I
-
-
6
6
-
-
2
2
-
-
2
2
D
D
i
i
a
a
g
g
n
n
o
o
s
s
e
e
With the analysis done by such page, possible path (static route, routing table or policy
route) of the packets sent out of the router can be traced.
or

Draytek Vigor2926L Specifications

General

Brand	Draytek
Model	Vigor2926L
Category	Network Router
Language	English