Draytek Vigor2926L User Manual

Vigor2926 Series User’s Guide
180
Such method is suitable for a user which has multiple ISP
accounts. With such method;
 All WANs of secondary routers can be up. Therefore,
the user can route it's traffic to secondary.
 WAN settings of primary and secondary routers must
not be the same.
 The Config Sync must be disabled, or you cannot change
redundancy method to active-standby.
Group ID Type a value (1~255).
In LAN environment, multiple routers can be devided into
several groups. Each router must be specified with one group
ID. Different routers with the same ID value will be
categoried into the same group.
Only one of the routers in the same group will be selected as
the primary router.
Priority ID Type a value (1~30).
Different routers must be configured with different IDs.
The router with the highest priority will be treated as
primary router. If multiple routers have the same priority,
the router with lower “IP” will be treated as primary. “IP” is
the IP address configured on LAN >> General Setup page, in
which LAN is determined by management interface.
Authentication Key Type a string as the authentication key (maximum 31
characters allowed).
It is used for encrypting the DARP to prevent malicious
attack.
Protocol Choose IPv4 or IPv6.
Management Interface Such interface is used for DARP (DrayTek Address
Redundancy Protocol) negotiation between routers. Only the
interface which is enabled in LAN>>General Setup is
available for selection.
However, LAN1 is always enabled.
Update DDNS Enable – Check the box to update the DDNS server for the
secondary device if required.
If the primary device fails, and the secondary device must
take over the job of data transmitting and receiving. Then
the system will update the DDNS server to make the user
connect to the specified domain name.
Syslog Enable – Check the box to record required information on
Syslog.
LAN1 ~ LAN6, DMZ Enable – Check the box to enable the interface.
Virtual IP - Type the IP address of the router plays the role of
Primary device.
I
I
I
I
-
-
5
5
-
-
1
1
2
2
-
-
2
2
C
C
o
o
n
n
f
f
i
i
g
g
S
S
y
y
n
n
c
c
This page is used to specify the synchronization time for such Vigor router and only available
when Hot-Standby method is specified and High Availability is enabled.

Draytek Vigor2926L Specifications

General

Brand	Draytek
Model	Vigor2926L
Category	Network Router
Language	English