Vigor2926 Series User’s Guide
181
Available settings are explained as follows:
Item Description
Enable Config Sync (Max.
Sync to 10 routers)
Check this box to enable configuration synchronization.
To sync configuration from primary to secondary router,
both primary and seconday routers need to enable “config
sync”. Note that config sync can be enabled by Hot-Standby
redundancy method only.
Config Sync Interval Day / Hour / Minute - Primary router will sync its
configuration to secondary router based on the time interval
set here.
Exclude the following
settings from config sync
Settings selected in this field will be excluded when
executing configuration synchronization. For example, under
active-standby mode, WAN settings will not be synchronized.
When you finish the configuration, please click OK to save and exit this page.
E
E
x
x
a
a
m
m
p
p
l
l
e
e
:
:
Take the following picture as an example. The upper Vigor2926 is regarded as primary device,
the lower Vigor2926 is regarded as secondary device. When primary Vigor2926 Series is
broken down, the secondary device could replace the primary role to take over all jobs as
soon as possible. However, once the primary device is working again, the secondary device
would be changed to original role to stand by.
To Next Page
Loading...
