Vigor2926 Series User’s Guide
275
I
I
V
V
-
-
1
1
-
-
3
3
S
S
I
I
P
P
A
A
c
c
c
c
o
o
u
u
n
n
t
t
s
s
In this section, you set up your own SIP settings. When you apply for an account, your SIP
service provider will give you an Account Name or user name, SIP Registrar, Proxy, and
Domain name. (The last three might be the same in some case). Then you can tell your folks
your SIP Address as in Account Name@ Domain name
As Vigor VoIP Router is turned on, it will first register with Registrar using
AuthorizationUser@Domain/Realm. After that, your call will be bypassed by SIP Proxy to the
destination using AccountName@Domain/Realm as identity.
Info
Selection items for Ring Port will differ according to the router you have.
Available settings are explained as follows:
Item Description
Index Click this link to access into next page for setting SIP
account.
Profile Display the profile name of the account.
Domain/Realm Display the domain name or IP address of the SIP registrar
server.
Proxy Display the domain name or IP address of the SIP proxy
server.
Account Name Display the account name of SIP address before @.
Codec Display the codec type for the account.
Ring Port Specify which port will ring when receiving a phone call.
Status Show the status for the corresponding SIP account. R means
such account is registered on SIP server successfully. – means
To Next Page
Loading...
Need help?
General
