Available settings are explained as follows:
Item Description
Enable Check to enable RADIUS client feature.
Server IP Address Enter the IP address of RADIUS server
Destination Port The UDP port number that the RADIUS server is using. The
default value is 1812, based on RFC 2138.
Shared Secret The RADIUS server and client share a secret that is used to
authenticate the messages sent between them. Both sides
must be configured to use the same shared secret. The
maximum length of the shared secret you can set is 36
characters.
Confirm Shared Secret Re-type the Shared Secret for confirmation.
After finished the above settings, click OK button to save the settings.
I
I
I
I
-
-
5
5
-
-
5
5
-
-
2
2
I
I
n
n
t
t
e
e
r
r
n
n
a
a
l
l
R
R
A
A
D
D
I
I
U
U
S
S
Except for being a built-in RADIUS client, Vigor router also can be operated as a RADIUS server
which performs security authentication by itself. This page is used to configure settings for
internal RADIUS server. Then LAN user of Vigor router will be authenticated by Vigor router
directly.
To Next Page
Loading...
