Vigor2926 Series User’s Guide
3
Switch on Rear Side (Jack for LTE device)
Interface Description
Factory Reset Restore the default settings. Usage: Turn on the router (ACT LED is
blinking). Press the hole and keep for more than 5 seconds. When you
see the ACT LED begins to blink rapidly than usual, release the button.
Then the router will restart with the factory default configuration.
LAN1~LAN5 Connecters for local network devices.
WAN1~WAN2 Connecter for local network devices or modem for accessing Internet.
USB1~USB2 Connector for a USB device (for 3G/4G USB Modem or printer or
Environmental Thermometer).
PWR Connecter for a power adapter.
ON/OFF Power Switch.
SIM Card Slot Connector for a SIM card.
To Next Page
Loading...
