Vigor2926 Series User’s Guide
708
n=0: PAP/CHAP (this is default setting)
n=1: PAP Only
-t n It means to set connection duration and n means different
conditions.
n=-1: Always-on
n=1 ~ 999: Idle time for offline (default 180 seconds)
-i <ip address> It means that PPPoE server will assign an IP address specified here
for CPE (PPPoE client).
If you type 0.0.0.0 as the <ip address>, ISP will assign suitable IP
address for you. However, if you type an IP address here, the router
will use that one as a fixed IP.
-w <ip address> It means to assign WAN IP address for such connection. Please type
an IP address here for WAN port.
-n <netmask> It means to assign netmask for WAN connection. You have to type
255.255.255.xxx (x is changeable) as the netmask for WAN port.
-g <gateway> It means to assign gateway IP for such WAN connection.
-s <server ip> It means to set PPTP/L2TP Server IP.
<server ip>= ppp.qqq.rrr.sss: PPTP/L2TP server IP
-A <idx> Set to Always On mode, and <idx> as backup WAN#.
-B <mode> Set to Backup mode.
<mode> 0: When any WAN disconnect; 1: When all WAN disconnect.
-V It means to view Internet Access profile.
-C <sim pin code> Set (PPP mode) SIM PIN code (max. 15 characters) for 3G/4G USB
Modem.
-O <init string> Set (PPP mode) Modem Initial String (max. 47 characters) for 3G/4G
USB Modem.
-T <init string2> Set (PPP mode) Modem Initial String2 (max. 47 characters) for
3G/4G USB Modem.
-D <dial string> Set (PPP mode) Modem Dial String (max. 31 characters) for 3G/4G
USB Modem.
-v <service name> Set (PPP mode) Service Name (max. 23 characters) for 3G/4G USB
Modem.
-m <ppp username> Set (PPP mode) PPP Username (max. 63 characters) for 3G/4G USB
Modem.
-o <ppp password> Set (PPP mode) PPP Password (max. 62 characters) for 3G/4G USB
Modem.
-e n Set (PPP mode) PPP Authentication Type for 3G/4G USB Modem.
n= 0: PAP/CHAP (default),
1: PAP Only
-q n (PPP mode) Index(1-15) in Schedule Setup-One
-x n (PPP mode) Index(1-15) in Schedule Setup-Two
-y n (PPP mode) Index(1-15) in Schedule Setup-Three
-z n (PPP mode) Index(1-15) in Schedule Setup-Four
-Q <mode> Set (PPP mode or DHCP mode) WAN Connection Detection Mode.
<mode>
0: ARP Detect;
1: Ping Detect
-I <ping ip> Set (PPP mode or DHCP mode) WAN Connection Detection Ping IP.
<ping ip>= ppp.qqq.rrr.sss: WAN Connection Detection Ping IP
To Next Page