Draytek Vigor2926L - Page 768

Vigor2926 Series User’s Guide
752
-e It means to enable or disable the flowtrack.
0: Disable
1: Enable
-f It means to show the sessions state of flowtrack. If you do not
specify any IP address, then all the session state of flowtrack will be
displayed.
-b It means to show all of IP sessions state.
- i [IP address] It means to specify IP address (e.g,, -i 192.168.2.55).
-p[value] It means to type a port number (e.g., -p 1024).
Available settings are 0 ~ 65535.
-t [value] It means to specify a protocol (e.g., -t tcp).
Available settings include:
tcp
udp
icmp
E
E
x
x
a
a
m
m
p
p
l
l
e
e
>ipf flowtrack set -r
Refresh the flowstate ok
> ipf flowtrack view -f
Start to show the flowtrack sessions state:
ORIGIN>> 192.168.1.11:59939 -> 8.8.8.8: 53 ,ifno=0
REPLY >> 8.8.8.8: 53 -> 192.168.1.11:59939 ,ifno=3
proto=17, age=93023180(3920), flag=203
ORIGIN>> 192.168.1.11:15073 -> 8.8.8.8: 53 ,ifno=0
REPLY >> 8.8.8.8: 53 -> 192.168.1.11:15073 ,ifno=3
proto=17, age=93025100(2000), flag=203
ORIGIN>> 192.168.1.11: 7247 -> 8.8.8.8: 53 ,ifno=0
REPLY >> 8.8.8.8: 53 -> 192.168.1.11: 7247 ,ifno=3
proto=17, age=93020100(7000), flag=203
End to show the flowtrack sessions state
T
T
e
e
l
l
n
n
e
e
t
t
C
C
o
o
m
m
m
m
a
a
n
n
d
d
:
:
i
i
p
p
f
f
f
f
l
l
o
o
w
w
t
t
e
e
s
s
t
t
This command is used to for RD debug in firewall diagnose.
S
S
y
y
n
n
t
t
a
a
x
x
ipf flowtest mode [<command><parameter>|…]
ipf flowtest set [index][option]
ipf flowtest send
ipf flowtest view
ipf flowtest reset
S
S
y
y
n
n
t
t
a
a
x
x
D
D
e
e
s
s
c
c
r
r
i
i
p
p
t
t
i
i
o
o
n
n
Parameter Description
mode
[<command>
<parameter>|…]
The available commands with parameters are listed below.
[…] means that you can type in several commands in one