Draytek Vigor2926L - Page 849

Vigor2926 Series User’s Guide
833
-e <1/0> Enable (1) or disable (0) User Access Log.
-c <1/0> Enable (1) or disable (0) Call Log.
-w <1/0> Enable (1) or disable (0) WAN Log.
-r <1/0> Enable (1) or disable (0) Router/DSL Information.
-t <1/0> Enable (1) or disable (0) AlertLog Setup.
-o <port number> Define the port number (1 ~ 65535) for AlertLog.
E
E
x
x
a
a
m
m
p
p
l
l
e
e
> sys syslog -a 1 -s 1 -i 192.168.1.25 -d 514
>
T
T
e
e
l
l
n
n
e
e
t
t
C
C
o
o
m
m
m
m
a
a
n
n
d
d
:
:
s
s
y
y
s
s
m
m
a
a
i
i
l
l
a
a
l
l
e
e
r
r
t
t
This command is used to configure settings for syslog mail alert.
S
S
y
y
n
n
t
t
a
a
x
x
sys mailalert [-<command> <parameter>]
S
S
y
y
n
n
t
t
a
a
x
x
D
D
e
e
s
s
c
c
r
r
i
i
p
p
t
t
i
i
o
o
n
n
Parameter Description
[<command><parameter>] The available commands with parameters are listed below.
-e [0/1] Enable/disable Mail Alert.
0 – Disable. 1 – Enable.
-i [SMTP Server IP] Set IP Address for SMTP server.
-o [SMTP Server Port] Set port number for SMTP server..
-a [Mail Address] Set E-maiil address for alert mail reciver.
-r [Mail Address] Set E-mail Address for mail return.
-s [0/1] Enable/disable the function of Use SSL.
0 – Disable. 1 – Enable.
-h [0/1] Enable/disable SMTP Authentication.
0 – Disable. 1 – Enable.
-u [Username] Set username for SMTP Authentication.
-p [Password] Set password for SMTP Authentication.
-l [type][0/1] Enable / disable mail alert for different types. Number 0 ~ 6
represent different types.
"0 <0/1>" : Enable/Disable Mail Alert of the DoS Attack.
"1 <0/1>" : Enable/Disable Mail Alert of the APPE.
"2 <0/1>" : nable/Disable Mail Alert of the VPN Log.
"3 <0/1>" : Enable/Disable Mail Alert of the APPE Signature.
"6 <0/1>" : Enable/Disable Mail Alert of the Reboot Debug Log.
In which,
0 – Disable. 1 – Enable.
-f Reset Mail Alert setting to factory default.
-v Show current Mail Alert setting.
-R [0/1] Set Mail Alert Reboot debug log mode.
0: Limited Mode
1: Unlimited Mode.
E
E
x
x
a
a
m
m
p
p
l
l
e
e