Draytek Vigor2926L - Page 869

Vigor2926 Series User’s Guide
853
clrev - clear phone hook status.
getev - get phone hook status.
clrfskcid - clear fsk data for caller-ID from PSTN line.
getfskcid - get fsk data for caller-ID from PSTN line.
clrdtmfcid - clear dtmf data for caller-ID from PSTN line.
getdtmfcid - get dtmf data for caller-ID from PSTN line.
voicebuf - get message for available voice buffer pool.
clrint - clear status for interrupt.
getint - get status for interrupt.
Vigor> voip dsp debugMsg getint
the interrupt status for ad0 = 21
the interrupt status for ad1 = 0
the interrupt status for vc = 0
voip dsp dtmfDetset
nLevel Set minimal signal level in dB, for DTMF detection.
Range – (-96 ~ -1)
nTwist Maximum allowed signal twist in dB, for DTMF detection.
Range – (0 ~ 12)
voip dsp dtmftonepwr
Level Set power level for DTMF frequency.
Level – 0 ~ 100. Power level for dtmf frequency in 0.3 dB steps.
0 map to 0dB
1 map to -0.3dB .... 100 map to -30dB
voip dsp cwtonepwr
ch Set the call waiting tone power level.
1 – FXS 1
2 – FXS 2.
value 1 ~ 30, in -1 dB increments, with 1 corresponding to 8 dBm.
voip dsp pstnringfxs
1|2 Enable or disable PSTN ring on FXS 1/FXS 2.
1 meansFXS1; 2 means FXS2.
on|off On means enable; off means disable.
voip dsp relaydbounce
on|off on: Enable relay filter noise. But it maybe ignore the caller-id!!!
off: Disable relay filter noise. But the noise will cause the relay to
switch to PSTN!!!
voip dsp setRingPat
ring_pattern_index This command can change the ring pattern at Index(2)~Index(6).
ring_pattern_index – Index (1) was locked for your country.
patten_num It's the ring pattern number (1~12) for a country.
--------------------------------------------
patten_num=1 Australia Ring Pattern:
cadenceOneOn=400, cadenceOneOff=200
cadenceTwoOn=400, cadenceTwoOff=2000
patten_num=2 Denmark Ring Pattern:
cadenceOneOn=1000, cadenceOneOff=4000
………………………………
voip dsp setFaxECmode -s