0 – disable
1 - enable
-N [name] Set SIP account display name.
Name - max. 23 characters.
-n [number] Set SIP account number.
Number - max. 63 characters.
-a [id] Set SIP authentication ID.
Id - max. 63 characters.
-A [enable] Enable /disable to use SIP authentication ID.
0 – disable
1 - enable
-p [passwd] Set SIP account password (max. 63 characters).
-e [sec] Set expiry time (default 3600) for SIP account.
-w [enable] Enable to make phone call without registering.
-m [mode] Set NAT traversal mode.
0 – disable
1 – stun
2 – manual
3 - nortel
-F [mode] Set call forwarding mode.
0 – disable
1 – always
2 – busy
3 - no answer
4 - busy or no answer
-u [url] Set SIP URL for call forwarding (max. 63 characters).
-t [sec] Set call forwarding timer. For example,
voip sip acc 1 –t 30
-g [port] Set the ring port for incoming call. For example,
Port - r1 means FXS1; r2 means FXS2.
-z [pattern] Set account ring pattern (1 ~ 6).
-i [enable] Remove all bindings while they are un-registered. 0 means Disable;
and 1 means Enable.
-B <enable> Enable / disable the function of Broadsoft Call Control.
0 – disable
1 - enable
-S [idx] Enable and use alias IP to register.
idx - 1 to 31. If 0 is used, such function will be disabled.
-k [num1 num2...] Set backup wan list (first wan, second wan...).
range: 1 to 4.
-v View current status for account settings.
Voip sip calllog Display current status for SIP call log.
voip sip ep
n The index number of the VoIP settings.
n – 1, 2.
-o [acc] Available dial out account (1 ~ 12).
-L [url] Set SIP URL (max. 63 characters) for hot line.
To Next Page
Loading...
