Draytek Vigor2926L - Page 899

Vigor2926 Series User’s Guide
883
wan lte send [number][message]
wan lte stus
wan lte tag [index #/all]
wan lte user [string]
wan lte wms [send[cdma/gwpp]/recv[cdma/gwgw]/setting]
S
S
y
y
n
n
t
t
a
a
x
x
D
D
e
e
s
s
c
c
r
r
i
i
p
p
t
t
i
i
o
o
n
n
Parameter Description
auth [0/1] Set PPP authentication of LTE WAN.
0: None.
1: PAP or CHAP.
band Display working band information for LTE network connection.
del [index #/all] Delete an SMS from the LTE SIM card by specifying the index
number. Use “all” to delete all.
pass Set the password of LTE WAN.
quota
[-<command><parameter>l…
]
Set settings of SMS Quota Limit function.
Available commands with parameter are listed below:
[...] means that you can type in several commands in one line.
-a <0/1>: Set whether to send an e-mail alert when SMS quota
exceeded. (0: no 1: yes)
-c <cycle>: Set the order of today in refresh cycle.
-d <day>: Set the refresh day.
-e <0/1>: Enable or disable SMS Quota Limit function. (0: disable 1:
enable)
-h <hour>: Set the refresh hour.
-m <0/1/2>: Set SMS quota refresh mode. (0: None 1: monthly 2:
periodically)
-n <number>: Set SMS quota. The avaible number is between 1 and
1000000.
-s <0/1>: Set whether to stop sending SMS after SMS quota
exceeded. (0: no 1: yes)
read Display information of an SMS in the LTE SIM card by specifying the
index number. Use "all" to display all.
reboot Set settings of Reboot on SMS Message function.
<command> <parameter> | ...
The available commands with parameters are listed below.
[...] means that you can type in several commands in one line.
-a <0/1>: Enable or disable Access Control List. (0: disable 1:
enable)
-e <0/1>: Enable or disable Reboot on SMS Message function. (0:
disable 1: enable)
-p <password>: Set the Password / PIN. This setting is necessary if
this function is enabled.
-x <number>: Set the first phone number in Access Control List.
-y <number>: Set the second phone number in Access Control List.
-z <number>: Set the third phone number in Access Control List.
reply Set settings of Reply with Router Status Message function.
<command> <parameter> | ...
The available commands with parameters are listed below.