0 – disable the function.
status It means to display WDS link status for 2.4GHz connection.
show It means to display current WDS settings.
mac add [index addr] add [index addr] – Add the peer MAC entry in Repeater/Bridge WDS
MAC table.
mac clear/disable/enable
[index/all]
clear/disable/enable [index/all]- Clear, disable, enable the
specifed or all MAC entries in Repeater/Bridge WDS MAC table. e.g,
wl dual wds mac enable 1
flush It means to reset all WDS setting.
E
E
x
x
a
a
m
m
p
p
l
l
e
e
> wl wds status
Please enable WDS hello function first.
> wl wds hello 1
% <Note> Please restart router after you set the parameters.
> wl wds status
T
T
e
e
l
l
n
n
e
e
t
t
C
C
o
o
m
m
m
m
a
a
n
n
d
d
:
:
w
w
l
l
a
a
p
p
c
c
l
l
i
i
This command allows users to configure AP client mode for wireless connection (2.4GHz).
S
S
y
y
n
n
t
t
a
a
x
x
wl apcli show
wl apcli enable [1/0]
wl apcli security [mode]
wl apcli ssid [ssid_name]
wl apcli bssid [mac address]
S
S
y
y
n
n
t
t
a
a
x
x
D
D
e
e
s
s
c
c
r
r
i
i
p
p
t
t
i
i
o
o
n
n
Parameter Description
show
Display current status of wireless AP client.
enable [1/0] It means to enable wireless 2.4GHz AP client mode.
1 – enable
0 – disable
security [mode] There are several modes to be selected:
Disable – disable the security settings.
wpapsk [key] – WPA Pre-shared Key will be used. Keys must start
with 0x to be identified as a Hexadecimal number key.
WPA keys must be in 8~63 ASCII string or 64
Hexadecimal digit format.
wpa2psk [key] – WPA2 Pre-shared Key will be used. Keys must start
with 0x to be identified as a Hexadecimal number key.
WPA keys must be in 8~63 ASCII string or 64
Hexadecimal digit format.
wpamixpsk [key] – WPA Mixed Pre-shared Key will be used. Keys
must start with 0x to be identified as a Hexadecimal
number key. WPA keys must be in 8~63 ASCII string or
64 Hexadecimal digit format.
wep [key] [index] – WEP key will be used. You need to type the key
To Next Page
Loading...
