> wl_dual drayrs show
% Mode : Strictly Minimun RSSI
% rs_low : -68
% rs_low_secure : -66
% delta : 2
T
T
e
e
l
l
n
n
e
e
t
t
C
C
o
o
m
m
m
m
a
a
n
n
d
d
:
:
r
r
a
a
d
d
i
i
u
u
s
s
This command allows you to configure detailed settings for RADIUS server
S
S
y
y
n
n
t
t
a
a
x
x
radius enable [0/1]
radius authport [port number]
radius set_auth_method [method idx]
radius client [add] [idx] -i [address] -m [mask] -p [prefix] -l [length] -s [secret]
radius client [del] [idx]
radius show
radius set_dot1x_phase1 -e [method_idx]
radius set_dot1x_phase1 -d [method_idx]
radius set_dot1x_phase2 -e [method_idx]
radius set_dot1x_phase2 -d [method_idx]
S
S
y
y
n
n
t
t
a
a
x
x
D
D
e
e
s
s
c
c
r
r
i
i
p
p
t
t
i
i
o
o
n
n
Parameter Description
enable[0/1] Enable (1) or disable (0) the RADIUS server.
authport [port number] Configure the port number for authentication.
Port number: Available range is from 0 to 65535.
Default value is “1812”.
set_auth_method [method
idx]
Specify which method will be used for authentication.
Method idx: “0” is “Only PAP”; “1” is
“PAP/CHAP/MS-CHAP/MS-CHAPv2”.
client add Specify a client to be authenticated by RADIUS server by typing
required information as follows:
-i [address]: client IPv4 address(domain)
-m [mask]: client IPv4 mask
-p [prefix]: client IPv6 prefix
-l [length]: client IPv6 prefix length
-s [secret]: shared secret
ex: radius client add 1 -i 192.168.1.1 -m 255.255.255.0 -s 123
client [del] [idx] del - Delete related settings for selected client.
Idx - Specify the index number of client profiles.
show Display the status of RADIUS server.
enable_dot1x [0/1] Enable (1) or disable (0) the 802.1X Authentication function of
RADIUS Server. Default is disabled.
set_dot1x_phase1
[method_idx]
Set the phase1 method for 802.1X authentication of RADIUS server.
To Next Page
Loading...
