7
I-2-3 Wireless Connection
VigorAP 903 can access Internet via an ADSL modem, router, or switch/hub in your network through
wireless connection.
1. Connect the A/C power adapter to the wall socket, and then connect it to the PWR connector of the
access point.
2. Power on VigorAP 903.
3. Check all LEDs on the front panel. ACT LED should be steadily on.
4. Connect VigorAP 903 to ADSL modem or router via wireless network.
(For the detailed information of LED status, please refer to section I-1-1.)
To Next Page
Loading...
