49
PinCode click Start PIN button. Both ACT and 2.4G WLAN LEDs on VigorAP 903
will blink quickly when WPS is in progress. It will return to normal condition
after two minutes. (You need to setup WPS within two minutes).
II-3-5 Advanced Setting
This page is to determine which algorithm will be selected for wireless transmission rate.
Available settings are explained as follows:
Item Description
Channel Width 20 MHz- the device will use 20MHz for data transmission and receiving
between the AP and the stations.
Auto 20/40 MHz– the AP will scan for nearby wireless AP, and then use
20MHz if the number of AP is more than 10, or use 40MHz if it's not.
40 MHz- the device will use 40MHz for data transmission and receiving
between the AP and the stations.
Packet-OVERDRIVE This feature can enhance the performance in data transmission about
40%* more (by checking Tx Burst). It is active only when both sides of
Access Point and Station (in wireless client) invoke this function at the
same time. That is, the wireless client must support this feature and invoke
the function, too.
Vigor N61 wireless adapter supports this function. Therefore, you can use
and install it into your PC for matching with Packet-OVERDRIVE (refer to
the following picture of Vigor N61 wireless utility window, choose Enable
To Next Page
Loading...
Need help?
General
