46
Item Description
Use internal RADIUS
Server
There is a RADIUS server built in VigorAP 903 which is used to authenticate
the wireless client connecting to the access point. Check this box to use the
internal RADIUS server for wireless security.
Besides, if you want to use the external RADIUS server for authentication,
do not check this box.
Please refer to the section, IV-1-1 RADIUS Server to configure settings
for internal server of VigorAP 903.
IP Address Enter the IP address of external RADIUS server.
Port The UDP port number that the external RADIUS server is using. The
default value is 1812, based on RFC 2138.
Shared Secret The external RADIUS server and client share a secret that is used to
authenticate the messages sent between them. Both sides must be
configured to use the same shared secret.
Session Timeout Set the maximum time of service provided before re-authentication. Set to
zero to perform another authentication immediately after the first
authentication has successfully completed. (The unit is second.)
After finishing this web page configuration, please click OK to save the settings.
To Next Page
Loading...
