DSC Neo - System Times

Section 6: Programming Worksheets
057 24 Hour Low
Temperature
a a a
CP-01
a
CP-01
a
060 24- Hr Non-
Latching
Tamper
a a
CP-01
a
CP-01
a
066 Momentary
Keyswitch Arm
a
067 Maintained
Keyswitch Arm
a
068 Momentary
Keyswitch
Disarm
a
069 Maintained
Keyswitch
Disarm
a
071 Door Bell
a a
072 Push to Set
a
6.3 System Times
[005] System Times
Description on page 70
000 – System Area
Bell Cutoff (Default: 004 minutes):
(3-Digit Decimal) Bell Delay Time (Default: 000 minutes):
Burglary Verification Timer (Default: 060 minutes):
Holdup Verification Timer (Default: 008 hours):
Zone Loop Response Time (Default: 025 x 10ms):
Automatic Clock Adjust (Default: 060 seconds):
001 – Partition 1 Timer
Entry Delay 1 (Default: 030):
Entry Delay 2 (Default: 045
CP-01
Default: 030):
Exit Delay (Default: 120
CP-01
Default: 060):
Settle Delay (Default: 010
CP-01
Default: 000):
002 – Partition 2 Timer
Entry Delay 1:
See partition 1 for defaults Entry Delay 2:
Exit Delay:
Settle Delay:
003 – Partition 3 Timer
Entry Delay 1:
- 130 -