To Next Page

To Previous Page

Section 5: Programming

5.3 Programming Descriptions

This section provides descriptions of all alarm controller options programmable by the installer.

5.3.1 Adding Labels

[000] Label Programming

Zone and other labels on the alarm system can be customized.

Program labels locally or download/upload using DLS. Local label programming is done via a system keypad, as described

below.

[000] Language Selection

(LCD keypads only)

Use this section to set the language displayed by LCD keypads. To select a language:

1. Enter Installer Programming: [*][8][Installer Code].

2. Enter programming section [000]>[000].

3. Key in the 2-digit number corresponding to the language required. See below:

01 = English 11 = Swedish 22 = Bulgarian

02 = Spanish 12 = Norwegian 23 = Latvian

03 = Portuguese 13 = Danish 24 = Lithuanian

04 = French 14 = Hebrew 25 = Ukrainian

05 = Italian 15 = Greek 26 = Slovakian

06 = Dutch 16 = Turkish 27 = Serbian

07 = Polish 18 = Croatian 28 = Estonian

08 = Czech 19 = Hungarian 29 = Slovenian

09 = Finnish 20 = Romanian

10 = German 21 = Russian

[001]-[128] Zone Labels

Customized labels can be created for each available zone. Labels can be programmed at the keypad or down-

loaded/uploaded using DLS. The maximum label size is 14 x 2 ASCII characters.

Manual Labels

The following procedure describes how to add zone labels using the LCD keypad:

1. Enter Installer Programming: [*][8][Installer Code].

2. Press [*], scroll to Zone Labels and press [*] again.The first zone is displayed. Alternately, press [000][001].

3. Scroll to the zone label to be programmed or key in the zone number. (e.g., 001 for zone label 1).

4. Scroll to the desired character’s location using the[<] [>] keys.

5. Enter the number of the corresponding character group until the desired character is displayed (see the following table).

Example: Press the “2” key 3 times to enter the letter “F.”

Press the “2” key 4 times to enter the number “2.”

To delete a character, use the [<] [>] keys to move the cursor under the character, then press [0].

If any key other than [<] or [>] is pressed before [0], the cursor moves one space to the right and deletes that char-

acter.

6. Press [#] to save the changes and exit.

- 61 -

DSC Neo User Manual

Questions and Answers: