To Next Page

To Previous Page

Appendix 3: Template Programming Tables

4 [401] Option 1 ON

Option 3 OFF

Option 4 ON

[406] 008

Double Call Enabled

Call Back Disabled

User Initiated Call Up Enabled

Number of Rings to Answer On is 8

After entering a valid 5-digit template programming code, the system prompts for the following data in the sequence listed:

1. Central Station Telephone Number

i. Program the required central station phone number. Press [#] to complete your entry.

ii. This phone number is entered into programming section [301][001].

2. Central Station System Account Code (4 or 6-digit code)

i. Program the system account code. Alldigits must be entered in order to complete your entry.

ii. This account code is entered into programming section [310][000].

3. Partition 1 Account Code (4 digit code)

i. Program the partition 1 account code. All digits must be entered in order to complete your entry.

ii. This account code is entered into programming section [310][001]

4. DLS Access Code (6-digit code)

i. Program the required DLS access code. All 6 digits must be entered in order to complete your entry.

ii. This access code is entered into programming section [403].

5. Entry Delay 1 and Exit Delay

i. Enter the 3-digit entry delay 1 (in seconds) followed by the desired 3-digit exit delay (in seconds). These entries affect

all partitions.

ii. All 3 digits must be entered in order to complete each section entry.

iii. These values are entered in programming sections [005][001]-[008] entry 1 and 3 respectively.

6. Installer's Code

i. Enter the 4 or 6-digit installer access code (dependent on section [041]). All digits must be entered in order to com-

plete the section entry.

ii. This code is entered into programming section [006][001].

iii. After the installer code has been programmed the system returns to the base installer programming menu.

iv. All template programming information defaults after performing a hardware or software panel default. The 5-digit tem-

plate programming code is defaulted to 00000.

Note: Pressing the pound key (#) advances through template programming, accepting what is displayed in these locations,

potentially overwriting desired programming. Depending on the option programmed, restoring the defaults using template

programming may not be possible.

- 207 -

DSC Neo User Manual

Questions and Answers: