3-8
Chapter 3 Advanced Operation
7
Input the paper length on the keypad.
Setting range :182.0 to 457.2 mm/7.17 to 18.00
inches
When the numerical value has been inputted,
press the clear key to clear the value before
inputting.
Example of inputting a value: Input [2500] when the paper length is 250 mm.
Paper Size Set
Set
Man
P Length
250.0
8
Press the key.
The inputted value will be set.
250 +0.0/
Ready
0
9
Press the key.
The procedures taken after that will be the same as the Chapter 2 “3. Standard Folding of Standard Paper”
(p.2-5).
3. Custom Folding
<Standard single fold> <Example of custom single fold>
Custom folding is an operation method to fold
paper at any position by specifying the folding
stopper positions (folding position) of the
folding plates 1 and 2.
Paper feed
direction
Paper
Length : 182 to 457.2/
7.17 to 18.00
Width : 120 to 311/
4.73 to 12.24
Unit : mm/inches
The foldable sizes are as follows. (Width x Length)
Maximum : 311 x 457.2 mm/12.24 x 18.00 inches
Minimum : 120 x 182 mm/4.73 x 7.17 inches
The paper sizes which can be used may vary
with the paper type, thickness, and printing
state.
To Next Page
Loading...
Need help?
General
