3-17
Chapter 3 Advanced Operation
4-3. Cross fold paper at the desired folding position
This is a method to cross-fold standard or non-standard paper at any desired positions. Standard paper or
non-standard paper is handled in the same way and cross-folded by using a method to register the folding
position as a custom folding.
1
Register custom folding referring to the procedures of “3. Custom Folding” (p.3-8).
2
Single-fold the paper in the custom folding mode.
3
Register the single-folded paper again as custom folding referring to the procedures of
“3. Custom Folding” (p.3-8).
4
Take procedures 2 to 15 of “4-1. Cross fold of standard paper” (p.3-13).
5. Changing the Stacker Roller Height
Some thick and sti paper may not be ejected smoothly because the paper may open after folding.
Change the stacker roller height and widen the space for the paper to pass in ejection.
1
Remove the auxiliary paper ejection guide.
2
Lift the stacker roller and hold it with hand to move to the [A] position shown in the
gure.
[A]
After completing folding operations, be sure to return the stacker roller to the standard
position. Leaving it in the raised state will result in poor alignment of ejected paper.
To Next Page
Loading...
