3-32
Chapter 3 Advanced Operation
12
Press the key.
Returns to [Other Setting].
13
Press the key.
Returns to the top screen.
7-13. Idling setting
Selecting [ON] on idling setting allows the machine to stand by idling when double-feed or mis-feed occurs,
or when paper processing operation is stopped by pressing the start key. Folding operation can be resumed
immediately by pressing the start key again as the machine’s functions other than the conveyance drive have
not been shut down completely.
Other Setting1/5
Feed Interval
Stack Roll Adj
Belt Convey Vol
1
Press the menu key to display [Other
Setting].
Other Setting4/5
Idling
Tone
mm/inch Setting
2
Select [Idling] with the or key.
Idling
OFF
3
Press the key.
The [Idling] screen is displayed.
4
Press the key.
At this stage [ON] or [OFF] can be changed.
5
Select [ON] or [OFF] with the or key.
Idling
ON
6
Press the key.
The selected item is set.
7
Press the key.
Returns to [Other Setting].
8
Press the key.
Returns to the top screen.
Idling operation will stop when the control panel is not operated more than 30 seconds in the idling
state.
Double-feed may occur depending on paper type when the air volume is adjusted in the idling state
and paper is fed again after operating for a long time in the idling state.
The air volume can be adjusted using a new key even in the idling state.
To Next Page
Loading...
Need help?
General
