4-6
Chapter 4 Using Options
16
Set the paper to the hand feed paper
feed guide of the hand feed paper feed
tray.
Do not insert the paper into the inlet.
Inserting paper into the inlet will result in
paper jam or injury as the sensor detects
and the paper is fed.
17
Set the auxiliary guide to the paper
side.
Set the auxiliary guide leaving some
clearance between the guide and paper.
Too much pressure may cause a paper
feeding error such as mis-feed, etc.
18
Insert a sheet of paper to perform test
folding.
Insert paper into the inlet, and the machine
will start feeding operation automatically to
process folding.
Compress the paper inside the machine to
insert paper into the inlet. If the paper is
not compressed enough, paper jam may
occur. If so, press the start key to eject
paper forcibly.
19
Check the nish of test folding.
Adjust the folding misalignment as required.
20
Select the method of using the counter.(Count Up and Count Down)
For the setting method, refer to the procedure 10
(p.2-8)
of Chapter 2 “3. Standard Folding of Standard
Paper”.
To Next Page
Loading...
Need help?
General
