Programming
298 Service Instructions 755 A/756 A - 00.0 - 02/2019
Information
The active pocket program has been set as the source.
2. Enter the source using the numeric keypad.
3. Confirm with OK.
The display returns to Copy pocket program.
4. Press the button.
5. Enter the destination using the numeric keypad.
Important
The destination program will be overwritten during the copying process.
If necessary, you will have to make additional adjustments in the software.
If selecting a destination that is already used in another sequence, you will
be shown a safety check message prompting you to confirm that you really
want to overwrite the sequence:
Fig. 283: Copying a pocket program (2)
6. Confirm with OK.
The selected pocket program is copied.
The message Copy was successful is displayed.
7. Confirm with OK.
The display switches to the selected seam program.
To Next Page
Loading...
