Stacker
248 Service Instructions 755 A/756 A - 00.0 - 02/2019
28.2.2 Aligning the throw-over stacker
Proper setting
The stacker brackets are positioned below the tabletop to prevent them
from picking up the sewing material prematurely while the fabric is passing
through.
The stacker brackets are positioned parallel to the stand at a distance of
approx. 2 cm.
Aligning the position of the throw-over stacker relative to the tabletop
Fig. 242: Aligning the throw-over stacker (1)
To align the position of the throw-over stacker relative to the tabletop:
1. Loosen screws (6) and (7).
2. Shift the position of the throw-over stacker in the slotted holes (2) to
set the distance to the stand.
 The stacker brackets (4) and (5) are positioned approx. 2 cm in front
of the stand.
3. Tighten the screws (6).
(1) - Slotted hole
(2) - Slotted holes
(3) - Tabletop
(4) - Stacker bracket
(5) - Stacker bracket
(6) - Screws
(7) - Screws
To Next Page
Loading...
Need help?
General
