DURKOPP ADLER 756 A

Programming
322 Service Instructions 755 A/756 A - 00.0 - 02/2019
Corner knife (slanted pocket, automatic corner knife station)
Important
Before you can set the corner knife parameters for the slanted pocket,
you must select the option Straight/Slanted pocket or automatic corner
knife station in the submenu Corner knife device in the Machine
configuration ( p. 348). After making the conversion in the
Machine configuration, you must restart the machine.
The display switches to Corner knife (Slanted pocket).
Fig. 304: Corner knife (slanted pocket)
Symbols Meaning
All corner knives UP/DOWN
Corner knife seam begin. left UP/DOWN
Correction seam begin. left  p. 323
• -9.9 mm - 9.9 mm
Correction seam begin. right  p. 323
• -9.9 mm - 9.9 mm
Corner knife seam begin. right UP/DOWN
Corner knife seam end left UP/DOWN