Programming
Service Instructions 755 A/756 A - 00.0 - 02/2019 365
USB logger
 The display switches to USB logger.
Fig. 335: USB logger
To perform a OP7000 logging:
1. Create a Log.txt file on a computer.
2. Load the Log.txt file onto a USB key.
3. Plug the USB key with the Log.txt file into the USB port on the control
panel.
4. Confirm with OK.
 OP7000 logging automatically writes all status messages of the
OP7000 to the Log.txt file until the machine is switched off.
Information
The DAC logging is performed by DA service technicians only.
Symbol Description
DAC modes:
• for DA service technicians only
To Next Page
Loading...
Need help?
General
