DURKOPP ADLER 867-M Premium - Parameter Selection (Parametercall) Submenu

Programming
102 Service Instructions 867-M PREMIUM - 02.0 - 02/2017
A further branching into the submenus cannot be shown here for reasons
of space. A corresponding overview of the menu items appears at the be-
ginning of each chapter.
20.3 Parameter selection (ParameterCall) submenu
The submenu is visible only if the ParameterView parameter ( p. 119)
is active. The settings for a parameter can be changed directly here.
To change the parameters:
1. Select the menu item Service > ParameterCall.
2. Press the OK button to confirm the selection.
 A window appears where the parameter can be selected:
Fig. 90: ParameterCall submenu
3. Select the level of the desired parameter with the ▲/▼ buttons.
4. Use the
► button to move to the Cat category and select the desired
value with the
▲/▼ buttons or the number keys. The categories are
explained in the  Parameter list 867-M PREMIUM.
5. Use the
► button to move to the Par parameter and select the desired
value with the
▲/▼ buttons or the number keys. The parameters are
explained in the  Parameter list 867-M PREMIUM.
6. Use the
► button to move to the fourth value on the far right. This value
may vary, depending on the parameter. It may be a mode or a window
with an action selection.
7. Enter parameter value and confirm by pressing OK.
Abbreviation Meaning
OOperator
T Technician
+
ParameterCall
Cat Par Mode
01 00 6
T
Lvl