DURKOPP ADLER 867-M Premium - Disassembling and Assembling the Throat Plate

Working basis
Service Instructions 867-M PREMIUM - 02.0 - 02/2017 21
3.4.6 Disassembling and assembling the throat plate
Fig. 10: Disassembling and assembling the throat plate
Disassembling the throat plate
To disassemble the throat plate:
1. Execute the service routine Feed Dog > Pos To Needle
( p. 14).
 The software is used to define the necessary presettings on the
machine.
2. Open the throat plate slide ( p. 20)
3. Loosen the screws (1).
4. Remove the throat plate (2).
5. Finish the service routine.
Assembling the throat plate
To assemble the throat plate:
1. Execute the service routine Feed Dog > Pos To Needle
( p. 14).
 The software is used to define the necessary presettings on the
machine.
2. Insert the throat plate (2).
 Ensure that the nose (4) of the bobbin case (3) is in the cutout of the
throat plate (2).
3. Tighten the screws (1).
4. Close the throat plate slide ( p. 20).
5. Finish the service routine.
(1) - Screws
(2) - Throat plate
(3) - Bobbin case
(4) - Nose
③
④
①
②