Dynamic DX2-REM550 User Manual

66 GBK60348: Issue 3
Profiles as well as smooth Drive Profiles in one wheelchair program. For example a
responsive sports profile and a smooth cruising profile.
Load Compensation Response
(if LC Response Profiled is set to ‘Yes’)
Location: DX2 Master Remote (profiles)
Set for each Drive Profile separately
LC Response Default
(if LC Response Profiled is set to ‘No’)
Location: DX2-PMA Power Module
One value for all Drive Profiles together
Value
Result
Value
Result
0 %
Profiled response disabled,
use LC Response Default
value for this profile
-
-
1 – 50 %
Too low; not recommended
-
-
50 – 70 %
Soft response
50 – 70 %
Soft response
70 – 90 %
Normal response
70 – 90 %
Normal response
90 – 99 %
Hard response
90 – 99 %
Hard response
100 %
Profiled response disabled,
use LC Response Default
value for this profile
100 %
Very hard response,
Load Compensation value not
lowered at any speed
For more information see the installation manual of the DX2 Power Module
Actuator System Type 4.2.2.6
Parameter
Possible Values
Default
HHP
Lite
Std
Adv
Actuator System Type
CLAM or TAM
DX2 Actuators
DX2 Actuators
-



It is not possible to use a CLAM/TAM and a DX2 Actuator Module simultaneously in a
DX System.
CLAM or TAM - The CLAM or TAM Module is enabled.
The DX2 Actuator Modules will not be detected, even if they
are connected to the DX System.
DX2 Actuators - The CLAM or TAM Module is disabled and will not be detected,
even if it is connected to the DX System.
The DX2 Actuator Modules will be detected successfully if they
are connected to the DX System.
Note:
A Wizard program (template) that is set up to include DX2 Actuator Modules
is required to configure the operation of the DX2 Actuator System.
Actuator System is Critical 4.2.2.7
Parameter
Possible Values
Default
HHP
Lite
Std
Adv
Actuator System is Critical
Yes/No
No
-




Dynamic DX2-REM550 Specifications

General

Brand	Dynamic
Model	DX2-REM550
Category	Video Game Controller
Language	English