UPR700 Microprocessor-Based Pressure/Process Indicator 5
INDEX
How to: See Section: Page
Wire the UPR700 6.1 20
Primary Input
Set the Primary Input Type 8.4.1, 8.4.3 27, 30
Set the Shunt Calibration 8.4.2 29
Set the Primary Input Full Scale Value 8.4.4 31
Set the Primary Input Failsafe Mode 8.4.7 31
Calibration of Primary Input
Calibrate the Primary Input to the instrument 9.1 42
With Internal Shunt 9.1.1, 9.1.2 42
With External Shunt 9.1.3 43
With Linear Input 9.1.4, 9.1.5 43
Secondary Input
Set the Secondary Input Type 8.5.1 32
Set the Secondary Input Scale Value 8.5.2 34
Set the Secondary Input Thermocouple Type 8.5.3 34
Set the Secondary Input Failsafe Mode 8.5.4 34
Alarms
Set which input the Alarms will Monitor 8.6.1 35
Set the Alarm Type (high, low, etc.) 8.6.2 35
Set the Reset Mode for Alarms 8.6.5 36
Set the Failsafe Mode for Alarms 8.6.6 37
Set the Alarm Value 8.6.7 37
Analog Output (retransmission)
Set the Main Analog Output 8.7 37
Set the Secondary Analog Output 8.7 37
Security
Set the Security Codes 8.8 40
Error Codes
Interpret the Error Codes and Troubleshoot 10.1 48
Instrument Maintenance and Repair
Perform Instrument Maintenance 10.3 49
Repair the Instrument 13 66
Get Technical Assistance 13 66
To Next Page
Loading...
Need help?
General