Dynisco UPR700 - ALARM 3 TYPE - Group 3; MAIN ANALOG OUTPUT LINK - Group 3; ALARM 3 INPUT CHANNEL LINK - Group 3; ALARM 2 TYPE - Group 3

58
Range: OFF, PrI.In, SEc.In. Disabled, primary input, secondary input.
Default value: Primary input.
ALARM 2 TYPE - Group 3
Available: Only if A2.LNK is different than OFF.
Upper display: Selection of alarm 2 type.
Lower display: A2.TYP
Range: HI, LO, InhIb. High, low, low with mask start-up
Default value: High.
ALARM 3 INPUT CHANNEL LINK - Group 3
Available: Only if Alarm 3 output is fitted.
Upper display: Configuration for alarm 3 selection.
Lower display: A3.LNK
Range: OFF, PrI.In, SEc.In. Disabled, primary input, secondary input.
Default value: Disabled.
ALARM 3 TYPE - Group 3
Available: Only if A3.LNK is different than OFF.
Upper display: Selection of alarm 3 type.
Lower display: A3.TYP
Range: HI, LO, InhIb. High, low, low with mask at start-up.
Default value: High.
MAIN ANALOG OUTPUT LINK - Group 3
Available: Only if SI.TYP is different than OFF.
Upper display: Selected type for man analog output.
Lower display: MO.LNK
Range: PrI.In, SEc.In. Primary input, secondary input.
Default value: Primary input.
MAIN ANALOG OUTPUT RANGE LOW - Group 3
Available: Only if MO.TYP is different than OFF.
Upper display: Range low for main analog output.
Lower display: MO.LO
Range: from 0 to PI.FSV (if PO.LNK = PrI.In) from -1000 to 3000 (if PO.LNK = SEc.In).
Default value: 0.