UPR700 Microprocessor-Based Pressure/Process Indicator 65
LOADING DEFAULT DATA - Group 5
Available: Only if access to level C is allowed.
Upper display: OFF
Lower display: DEFLT
Range: Use ▼ ▲ keys to switch the upper display from OFF to On 5, then press FUNC key
to load the default data of the parameters belonging to group 1, group 2, group 3,
group 4 and group 5.
12.6 GROUP 6 SECURITY CODES SETTING
The security codes setting is accessible by setting an internal dip-switch (see Pg. 37) for the security
mode. There are three security levels. When each level has been assigned a code, access to the
parameters will be available as follows:
• level A: access to parameter group 1.
• level B: access to parameter groups 1 and 2.
• level C: access to parameter groups 1, 2, 3, 4 and 5.
SECURITY CODE - LEVEL A
Available: Always.
Upper display: 0, 1, On.
Lower display: CODE.A
Range: Use ▼ ▲ keys to input the security codes. 0 means no security code (all parameters
related to level A are always unlocked). 1 means no security code (all parameters
related to level A, level B and level C are always locked). A number from 2 to 250
is the code for level A protection.
SECURITY CODE - LEVEL B
Available: Only if CODE.A is 0 or On.
Upper display: 0, 1, On.
Lower display: CODE.B
Range: Use ▼ ▲ keys to input the security codes. 0 means no security code (the
parameters related to level A and level B are always unlocked). 1 means no security
code (all parameters related to level B and level C are always locked). A number
from 251 to 500 is the code for level B protection.
SECURITY CODE - LEVEL C
Available: Only if CODE.B is 0 or On.
Upper display: 0, 1, On.
Lower display: CODE.C
Range: Use ▼ ▲ keys to input security codes. 0 means no security code (the parameters
To Next Page
Loading...