UPR700 Microprocessor-Based Pressure/Process Indicator 51
IEC 1000-4-4: Electromagnetic compatibility (EMC) - Part 4: Testing and measurement
techniques - Section 4: Electrical fast transient/burst immunity test
ENV50141: Electromagnetic compatibility - Basic immunity standard - Conducted
disturbances induced by radio-frequency fields - Immunity test
12. PARAMETER GROUP MENUS
Group I Function Sec. As Set
AL.MSK Alarms Mask Reset 8.6.8
SECUR Security 8.8.3
AL1 Alarm 1 Threshold 8.6.7
AL2 Alarm 2 Threshold 8.6.7
AL3 Alarm 3 Threshold 8.6.7
DEFLT Loading Default Data 8.3.0
GROUP Group Access Number N/A
Group 2 Function Sec. As Set
ZERO.C Zero Calibration 9.1.X
SPAN.C Span Calibration 9.1.X
DSP.FL Display Filter 8.3.5
A1.FL Alarm 1 Filter 8.6.3
A2.FL Alarm 2 Filter 8.6.3
A3.FL Alarm 3 Filter 8.6.3
MO.FL Main Analog Output Filter 8.7.5
SO.FL Second Analog Ouput Filter 8.7.5
DEFLT Loading Default Data 8.3.0
Group 3 Function Sec. As Set
PI.FSV Primary Input Full Scale Value 8.4.4
PI.LSV Primary Input Low Scale Value 8.4.5
PI.DP Primary Input Decimal Point Position 8.4.6
SI.TC Secondary Input Thermocouple Type 8.5.3
Sl.C/F Engineering Unit For Secondary Input 8.5.4
SI.LO Secondary Input Range Low 8.5.7
Sl.Hl Secondary Input Range High 8.5.7
SI.DP Secondary Input Decimal Point System 8.5.7
A1.LNK Alarm 1 Input Channel Link 8.6.1
A1.TYP Alarm 1 Type 8.6.2
A2.LNK Alarm 2 Input Channel Link 8.6.1
A2.TYP Alarm 2 Type 8.6.2
A3.LNK Alarm 3 Input Channel Link 8.6.1
A3.TYP Alarm 3 Type 8.6.2
MO.LNK Main Analog Output Link 8.7.2
MO.LO Main Output Range Low 8.7.3
MO.HI Main Output Range High 8.7.4
To Next Page
Loading...