DMI
18
11/04 MN01219002Z-EN
Mounting on a top-hat rail
X Hook the DMI diagonally on the top edge of the top-hat
rail. Slightly press the device down and onto the top-hat
rail until it snaps over the bottom edge of the top-hat rail.
The spring mechanism will cause the DMI to clip into place
automatically.
X Check that the device is seated securely.
Vertical mounting on a top-hat rail is carried out in the same
way.
Connecting fieldbus modules
The fieldbus modules can be connected to the DMI easily
using an EASY-LINK-DS jumper (a fig. 2, Page 19).
A separate power supply is required for this. For further
information on this refer to a chapter “NZM-XDMI-DPV1
(PROFIBUS-DPV1 Interface for DMI)”, Page 75.
1
2
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
