Data interrogation
33
11/04 MN01219002Z-EN
Represent.
The DMI is factory set to display all currents as relative
values, i.e. as % values of I
r
. It is therefore factory set to
correspond to the markings on the NZM. However, absolute
values are also possible in Amps.
X Make the selection in the Represent. display menu.
The following screen shows Absolute and the setting Y (=
Yes) or N (= No).
X Use the cursor buttons to select between Y and N.
X Confirm the setting with OK.
Incorporating values in the Standard display
For example, you can show important parameters, the status
of the digital inputs and the current time in the display.
X Select a submenu, e.g. Currents in the Display menu.
X Use the cursor buttons Í or Ú to select the required
parameter, e.g. I
1
.
X Confirm the selection by pressing OK.
The value for I
1
is incorporated in the Standard display (a
following Section “The standard display”).
The standard display
X In the main menu use cursor buttons Í or Ú to select
Display.
X Confirm your selection by pressing OK.
h
The standard display appears automatically in the LCD
display if buttons on the DMI have remained in a non-
actuated state for 30 seconds or longer. It is only
overwritten by alarm messages from the NZM (a section
“Alarm messages”, Page 66).
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
