PROFIBUS-DPV1 functions
161
11/04 MN01219002Z-EN
Display of used parameters
The display of the parameters for currents which are used
depends on the form of representation selected in the DMI,
and is either an absolute value in Amps or relative to I
r
or I
n
.
The representation form can be selected via the
PROFIBUS-DP with the aid of the DMI object basic settings.
In the default state, the relative representation option is
preselected. The display of the used time parameters is
always absolute.
12 Current value: I
nrms
13 Current value: I
dnrms
14 Selected motor-starter function
15 Motor state
16 Current state of the inputs I0 to I5
17 Current state of the outputs Q0 to Q5
18
Time
19 Date
Value for standard
display
assignment
(decimal)
Meaning, displayed in the selected
line:
h
Please note that you can only display used parameters and
currents which the connected circuit-breaker actually
provides. If you select a parameter or current which is not
available, the selected line is not displayed.
h
Please note that the “No display” selection for a selected
line also has the effect that all following lines are not
represented on the DMI.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
