NZM-XDMI-DPV1
(PROFIBUS-DPV1 Interface for
DMI)
82
11/04 MN01219002Z-EN
X Set the required PROFIBUS address via the display and
keypad on the DMI (a section “COM”, Page 54).
X Configure the PROFIBUS-DP line.
X Transfer the new configuration to the master (a section
“Configuration of the class 1 DP master”, Page 84).
X Start the PROFIBUS-DP master.
After these steps, the communication between the DMI and
Interface as well as between the PROFIBUS-DP master and
interface must be established. Verify this fact using the LEDs
installed in the NZM-XDMI-DPV1 (a section “LED status
displays”, Page 82).
LED status displays
The NZM-XDMI-DPV1 has two display LEDs.
POW LED, function
Figure 18: POW LED display function
a LED continuously lit:
– supply voltage present
– communication to DMI interrupted
b LED flashes:
– supply voltage present
– communication with DMI in order
c LED not on:
– no supply voltage present
– communication with the DMI interrupted
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
