Eaton Power Xpert C445 - Page 338

Appendix D—Modbus Register Map
324 Power Xpert C445 Global Motor Management Relay MN042003EN—January 2019 www.eaton.com
716 Q2 Function Select UINT16 RW NV
Default: 55
Enum
Config CRC
Run Lock
Admin Lock
USB Lock
Backup Mem
Output Function Select for General Purpose Output 2. Available when this
output is not used by the Operation Mode. Default = none, If used by the
Application Mode = Reserved. A soft reset is required after modifying this
parameter.
Table 128. C445 Modbus Register Map, continued
Register Name Attribute Description
Value Description
0None
1 Fault Reason Type - Load fault (Power based)
2 Fault Reason Type - Supply fault (Voltage based)
3 Fault Reason Type - Motor fault (Current based)
4 Tripped Status Bits - PTC
5 Tripped Status Bits - Phase rotation mismatch
6 Tripped Status Bits - Stall
7 Tripped Status Bits - Overload
8 Tripped Status Bits - Starts limit exceeded
9 Tripped Status Bits - Low power
10 Tripped Status Bits - High power
11 Tripped Status Bits - Under current
12 Tripped Status Bits - Frequency deviation slow
13 Tripped Status Bits - Frequency deviation fast
14 Tripped Status Bits - Voltage unbalanc
e
15 Tripped Status Bits - Voltage phase loss
16 Tripped Status Bits - Power factor deviation
17 Tripped Status Bits - Jam
18 Tripped Status Bits - Instantaneous over current
19 Tripped Status Bits - Current unbalance
20 Tripped Status Bits - Current phase loss
21 Tripped Status Bits - Ground current
22 Motor Control Status - Motor at speed
23 Motor Control Status - Ready
24 Motor Control Status - Inhibited
25 Motor Control Status - Warning
26 Motor Control Status - Faulted
27 Motor Control Status - Remote enabled
28 Motor Control Status - Running 2
29 Motor Control Status - Running 1
30 Warning Status Bits - PTC
31 Warning Status Bits - Phase rotation mismatch
32 Warning Status Bits - Stall
33 Warning Status Bits - Overload
34 Warning Status Bits - Starts limit exceeded
35 Warning Status Bits - Low power
36 Warning Status Bits - High power
37 Warning Status Bits - Under curr
ent
38 Warning Status Bits - Frequency deviation slow
39 Warning Status Bits - Frequency deviation fast