Eaton Power Xpert C445 - Page 339

Appendix D—Modbus Register Map
Power Xpert C445 Global Motor Management Relay MN042003EN—January 2019 www.eaton.com 325
716 Q2 Function Select UINT16 RW NV
Default: 55
Enum
Config CRC
Run Lock
Admin Lock
USB Lock
Backup Mem
Output Function Select for General Purpose Output 2. Available when this
output is not used by the Operation Mode. Default = none, If used by the
Application Mode = Reserved. A soft reset is required after modifying this
parameter, continued.
Table 128. C445 Modbus Register Map, continued
Register Name Attribute Description
Value Description
40 Warning Status Bits - Voltage unbalance
41 Warning Status Bits - Voltage phase loss
42 Warning Status Bits - Power factor deviation
43 Warning Status Bits - Jam
44 Warning Status Bits - Instantaneous over current
45 Warning Status Bits - Current unbalance
46 Warning Status Bits - Current phase loss
47 Warning Status Bits - Ground current
48 Warning Status Bits - Reserved
49 Warning Status Bits - Over voltage
50 Warning Status Bits - Under voltage
51 Tripped Status Bits - Under voltage
52 Tr
ipped Status Bits - Over voltage
53 Tripped Status Bits - Reserved
54 Base Control Module Field Output control word - Bit 0
55 Base Control Module Field Output control word - Bit 1
56 Base Control Module Field Output control word - Bit 2
57 Base Control Module Field Output control word - Bit 3
58 Shunt trip output bit - Shunt trip output bit
59 Warning Reason - HRGF pulse detection
60 Warning Reason - Peak demand
61 Digital Input Status - Base Control Module Input I4
62 Digital Input Status - Base Control Module Input I3
63 Digital Input Status - Base Control Module Input I2
64 Digital Input Status - Base Cont
rol Module Input I1
65 Fail Safe - Ground current fault
65535 Reserved