Chapter 4—System Configuration and Commissioning
Power Xpert C445 Global Motor Management Relay MN042003EN—January 2019 www.eaton.com 47
3. Web Pages can be easily accessed using any web browser and an Ethernet cable
connected between the computer running the Power Xpert inControl Software and
the optional Ethernet card connected to the C445 Base Control Module.
An IP address or IP addressing method must be selected using the DIP Switches
on the Base Control Module. Refer to Installation and Wiring on Page 10 for
information on setting the DIP Switches when an Ethernet Card is installed in the
C445 Base Control Module. The computer must then be configured with an IP
address in the same range as the C445 Ethernet card.
Connect an Ethernet cable between the computer and the C445 Ethernet Card.
Enter the IP address of the C445 Ethernet Card on the command line in the web
browser and press the Enter key. In a few seconds, the Web Pages for the C445
will open as follows:
All parameters can be accessed or parameters in specific categories. The Web Pages can
be used to configure parameters, monitor and control.
To Next Page
Loading...
