5 Application example – CANopen fieldbus connection on DA1 variable frequency drives
5.2 Materials required
CANopen for DA1, DC1, DE11 09/16 MN040019EN www.eaton.com 79
Visualization details
Abbreviation Description
HAND Manual variable frequency drive start
START
Automatic variable frequency drive start
STOP Stops the variable frequency drive
Anticlockwise Reverses the operating direction
Fast stop
Quick Stop
Setpoint = 0
The setpoint value will be set to 0.
FF1
Activates fixed frequency 1.
Fault Reset Resets the current fault
Set point Setpoint input
Ready
Variable frequency drive is ready for operations
Run
Variable frequency drive running
Drive stopped Variable frequency drive stopped
Anticlockwise
The motor will run in reverse
Setpoint = 0 Variable frequency drive is released. The setpoint will be 0.
FF1 Fixed frequency 1 activated
Speed Actual value
Current Motor current
Error
Will show the current fault.
AUTOP
Not used as of this writing
START Not used as of this writing
STOP Not used as of this writing
To Next Page
Loading...
