Eaton PowerXL DA1 - 2.3.4 Residual current circuit-breaker

4 CANopen communication settings
4.7 Parameters
40 CANopen for DA1, DC1, DE11 09/16 MN040019EN www.eaton.com
4.7 Parameters
The following tables show the CANopen parameters on the variable
frequency drive/variable speed starter.
The abbreviations and acronyms used in the table are defined below:
Abbreviation Significance
CANopen Index The parameter‘s identification number in CANopen (identification number)
RUN The parameter can be accessed during operation (Run signal)
STOP
The parameter can only be accessed in STOP mode
ro/rw Parameter read and write permissions:
ro = read only
rw = read and write
Designation
Name of parameter
Value • Setting value of the parameter
• value range
• Display value
DS Default setting (the parameter's value when using the device‘s factory settings)
The values in parentheses are the default settings when using a frequency of 60 Hz.
Page
The page number in this manual containing a detailed description of the parameter.